Frontpoint Control Panel Wall Mount

The hub is the brains of your alarm system and the keypad is how you control it.

Frontpoint control panel wall mount.

For a desktop setup the touchscreen comes with two supporting brackets. Two included adhesives to adhere it flat against the wall or in a corner or you can place it directly on a shelf. From the frontpoint app test opening the door with the tilt sensor mounted. Before mounting the panel to a wall.

Unprecedented control is just steps away. Move the control panel to final location and send rediscover network signal. All frontpoint systems come with a wall mounted or tabletop controller that serves as your primary interface. For a wall mount setup the touchscreen comes with wall mounting bracket and screws.

The hub is the brains of your alarm system and the keypad is how you control it. Yes your control panel can be mounted on a flat wall surface using size appropriate screws. Www frontpoint com help control panel it all starts here. The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.

This countdown is called the entry delay which is the amount of time you have when entering the home to disarm the system by entering your 4 digit code into the control panel. You can arm and disarm the system from the panel check the weather view sensor status. Touch screen control panel. Test opening the door from frontpoint app again.

Attach the brackets then place the device where you want it. Make sure the sensor is mounted with the arrow pointed towards the ceiling. There are no phonelines to cut the system is. Keep note of the red battery wires and ac wires both should be going out through an oval or square hole on the back plate.

Close the door and mount tilt sensor on the door. Www frontpoint com help a b c do not mount sensor directly on a window glass break sensor. The touchscreen control panel has desktop setup and wall mounting options. Once the control panel is fully armed and a door sensor is tripped the control panel will beep for 30 seconds.

Every frontpoint system uses the frontpoint hub and keypad as the central command center. Every frontpoint system uses the frontpoint hub and keypad as the central command center. Use the appropriate screws not included to mount the base plate to the wall remount the panel onto the hinge and close the panel. The control panel serves as the nerve center for your system.

The screws are not provided with the panel itself and must be acquired by going to your local hardware store. They run on a 100 cellular connection with a built in wi fi backup. Get your system up and running starting with your control panel.